知識庫

Use OpenManage Switch Administrator to change the Privileged Exec (enable) password on the 3500, 5500, 6200, 7000, 8000, 8100, N2000, N3000, N4000 series switches


Article Summary: This article provides the necessary steps to add or change the Privileged Exec password from the web interface.

Discussion: Some firmware releases may not have required an enable password to be set when using telnet or SSH for switch management. If firmware is upgraded such that an enable password is required, it can be set via console or via the web interface. This article outlines the procedure for setting the enable password via the web interface.





1. Open the Dell OpenManage Switch Administrator web interface by entering the IP address of the switch in your web browser. Expanding the directories can be done by clicking on the title of each directory, clicking on the + symbol to each category’s title, or clicking directly on each of the options within the main window.

2. Navigate through: System > Management Security > Enable Password

3. Enter a new Enable password and click Apply.

Note: The 3500 and 5500 series switches may require entering an Enable Access Level. The default value of 1 only gives read access. Select 15 to give read/write access.

4. Save the configuration: Click on the diskette icon at the top of the window and acknowledge the warning.

Note: A 6200 series switch does not have a save icon. Navigate through: System > File Management > Copy Files. Select Copy Configuration, verify Source: Running Config and Destination: Startup Config, then select Apply Changes.


文章 ID: HOW10468

上次修改日期: 06/09/2016 07:56 AM


為本文評分

準確
實用
易懂
這篇文章對您有用嗎?
傳送意見反應
評語中不得包含下列特殊字元:<>()\
很抱歉,我們的意見回饋系統目前關閉中。請稍後再試。

感謝您的寶貴意見。