Knowledge Base

Force 10 - Link connectivity for DAC (Twinax) cables on Force 10 switches.

Article summary: This article explains how to resolve connectivity issues with DAC (Twinax) cables.

When using DAC (Direct attached copper, also known as Twinax) cables, you may run into link connectivity issues when not using cr4 auto negotiation. This is resolved by enabling cr4 auto negotiation, which is not enabled by default. The example below shows how to do this on interface 37 on unit 0, and then saves the configuration.



Ftos(config)#interface fortyGigE 0/37

Ftos(config-if-fo-0/37)#intf-type cr4 autoneg


Ftos#write memory

Note: This command is only applicable on Forty-Gigabit Ethernet interfaces.

To remove the above configuration run the following command in the interface configuration.

Ftos(config-if-fo-0/37)#no intf-type cr4 autoneg

Article ID: SLN295403

Last Date Modified: 04/21/2016 04:14 AM

Rate this article

Easy to understand
Was this article helpful?
Yes No
Send us feedback
Comments cannot contain these special characters: <>()\
Sorry, our feedback system is currently down. Please try again later.

Thank you for your feedback.