Knowledge Base

OptiPlex FX130: DeTOS Installation and Recovery


Article Summary: Article describes information on Installation and Recovery of Embedded Linux operating system used with your FX130 system.


Table of Contents:
  1. Installation and Recovery



1.


Installation and Recovery




No installation is required for customers who have purchased DeTOS based thin clients from Dell. The system will contain a factory installed DeTOS operating system. A USB re-flash utility is, however, available if the need to reinstall the operating sytsem arises at any point in the future.

Obtaining the Image:

To download the USB re-flash utility, please visit the Dell support website and download the filename Devon IT OS Re-flash Utility Dell Edition.






Click the button below to Tweet feedback or request assistance on anything in the above article. Twitter

 


Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Article ID: SLN286280

Last Date Modified: 01/06/2014 12:00 AM


Rate this article

Accurate
Useful
Easy to understand
Was this article helpful?
Yes No
Send us feedback
Comments cannot contain these special characters: <>()\
Sorry, our feedback system is currently down. Please try again later.

Thank you for your feedback.