Base de connaissances

Latitude E6420 and ATG Removal Guide for the Express card, SD card, Battery, SIM and Optical Drive



Table of Contents:

  1. Express Card Removal
  2. SD Card Removal
  3. Battery Removal
  4. SIM Card Removal
  5. Optical Drive Removal


This article provides information on removing components from a Latitude E6420 & E6420 ATG.



1. Express Card Removal


1. Pre-Removal Instructions Before removing the Express Card:

NOTE: The assembly and disassembly steps shown are for an Express card blanking plate, this still applies to any Express card.


  • During installation or removal of any hardware always ensure all data is backed up properly

2. Push in the dummy card into the slot.




3. Remove the card.




4. Complete.




Back to Top



2. SD Card


1. Pre-Removal Instructions Before removing the Media Card:

NOTE: The assembly and disassembly steps shown are for an SD card blanking plate, but still apply to any SD card.

  • During installation or removal of any hardware always ensure all data is backed up properly

2. Push in the SD card into the slot.




3. Remove the SD card from the system.




Back to Top



3. Battery


1. Pre-Removal Instructions Before removing the Battery:

  • During installation or removal of any hardware always ensure all data is backed up properly
  • Disconnect any telephone, network, or USB cables from the computer
  • Disconnect the computer and all attached devices from their electrical outlets

2. Release the two latches.




3. Lift up and remove the battery from the system.




4. Complete




Back to Top



4. SIM Card


1. Pre-Removal Instructions Before removing the SIM card:

  • During installation or removal of any hardware always ensure all data is backed up properly
  • Disconnect any telephone, network, or USB cables from the computer
  • Disconnect the computer and all attached devices from their electrical outlets
  • Remove the Battery

2. Push in the SIM card gently to release it.




3. Remove the SIM card from the system.




Back to Top



5. Optical Drive Removal


1. Pre-Removal Instructions Before removing the Optical Drive:

  • During installation or removal of any hardware always ensure all data is backed up properly
  • Disconnect any telephone, network, or USB cables from the computer
  • Disconnect the computer and all attached devices from their electrical outlets

2. Establishing image.




3. Push in the eject handle on the optical drive to release it.




4. Push in the eject handle on the optical drive to release it.




5. Pull out the right then left side of the optical drive door to remove the bezel.




6. Complete.





Return to the Latitude E6420 and E6420 ATG Teardown/Removal Index.


Back to Top


If you require further assistance or wish to give us feedback, please engage our technical team on Twitter.





Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

ID de l'article : SLN288585

Date de la dernière modification : 09/30/2014 05:35 AM


Noter cet article

Précis
Utile
Facile à comprendre
Avez-vous trouvé cet article utile ?
Oui Non
Envoyez-nous vos commentaires
Les commentaires ne doivent pas contenir les caractères spéciaux : <>()\
Désolé, notre système de collecte des commentaires est actuellement indisponible. Veuillez réessayer ultérieurement.

Merci pour vos commentaires.