Turn the printer on to its side to expose the blue plastic duplex tray and sensor.
The duplex tray is held in place by two mounting points, one closed...
...and one open.
If the tray is not mounted correctly or the spring does not hold the tray flat to the bottom of the printer, reseat the duplex tray.
Check the duplex sensor moves freely and springs back into place when released.
Back to Top If you require further assistance or wish to give us feedback, please engage our technical team on Twitter.
Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.