Databáze znalostí

1394a PCIe 1.0 (Firewire) card causes reboot on shutdown or enter a reboot loop when installed in OptiPlex 3020



This article contains information regarding "1394a PCIe 1.0 (Firewire) card causes reboot on shutdown or enter a reboot loop when installed in OptiPlex 3020".


1394a PCIe 1.0 (Firewire) card causes reboot on shutdown

Some OptiPlex 3020 system users have reported issues on shutdown after installation of a 1x PCIe 1.0 1394a (Firewire) network card in the system. Systems included rebooting of the system when shutdown selected or the system entering a reboot loop requiring the system to be hard powered off by pressing and holding the POWER button till the power supply turns off. When the card is removed, the issue no longer occurred.

Flashing the BIOS to the most current version had no effect.


Change Wake on LAN (WOL) BIOS setting

A workaround was discovered for this issue.

Entering the Basic Input/Output System (BIOS) and changing the Wake on LAN (WOL) setting from the default Disabled to Enabled allowed the system to operate normally.


Click the button below to Tweet feedback or request assistance on anything in the above article.




ID článku: SLN291769

Datum poslední změny: 09/15/2014 09:11 AM


Zhodnoťte tento článek

Přesné
Užitečné
Snadno srozumitelné
Byl tento článek užitečný?
Ano Ne
Zašlete nám svůj názor
Komentáře nesmí obsahovat tyto speciální znaky: <>() \
Je nám líto, ale náš systém zpětné vazby je v současné době mimo provoz. Zkuste to později.

Děkujeme za váš názor.