Knowledge Base

How To Reset The PC Counter On The 3330dn Dell Laser Printer


Article Summary: This article explains how to reset the PC Counter on the 3330dn Dell Laser Printer


Table of Contents:

  1. Reset The PC Counter



1. Reset The PC Counter

  1. Turn the printer off
  2. Press and hold down the Check Button and the Right Arrow Button on the printer
  3. Turn the printer back on
  4. Release your fingers from the buttons when the message Performing Self Test appears
  5. Press the Left Arrow Button or the Right Arrow Button to scroll to Reset PC Count, then press the Select Button
  6. After the Resetting message, press the Left Arrow Button or the Right Arrow Button to scroll to Exit Config
  7. Press the Select Button to restart the printer and apply the changes

Note: These steps should only be performed after replacing the Imaging Drum Cartridge


Back to Top




Click the button below to Tweet feedback or request assistance on anything in the above article.

 


Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Article ID: SLN288447

Last Date Modified: 01/15/2014 12:00 AM


Rate this article

Accurate
Useful
Easy to understand
Was this article helpful?
Yes No
Send us feedback
Comments cannot contain these special characters: <>()\
Sorry, our feedback system is currently down. Please try again later.

Thank you for your feedback.