Consulta de temas

How to configure SMTP Virtual server and Receive Connector in Exchange 2007/2010



Article Summary: This article provides information about how to configure SMTP Virtual server and Receive Connector in Exchange 2007/2010


Exchange needs a properly configured SMTP Virtual server/Receive connector to allow other mail servers to connect to your mail server to deliver the message.

By using EMC (Exchange management console) to expand Server Configuration and select Hub transport


Select the HUB server and check it has receive connectors Default and Client

Right click on Default receive connector and go to properties

Check if "anonymous" entry is checked on security groups tab.

On the network tab configure the correct IPs.

Check for all the listed hub transport servers.




Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Identificación del artículo: SLN285709

Última fecha de modificación: 10/30/2014 12:53 PM


Califique este artículo

Preciso
Útil
Fácil de comprender
¿Este artículo fue útil?
No
Envíenos sus comentarios
Los comentarios no pueden contener estos caracteres especiales: <>"(", ")", "\"
Disculpe, nuestro sistema de comentarios está actualmente inactivo. Vuelva a intentarlo más tarde.

Muchas gracias por sus comentarios.