Consulta de temas

CMC getniccfg Does Not Get VLAN Info


Article Summary: This article provides information on CMC getniccfg does not get VLAN info.




Question

The PowerEdge M1000e™ Chassis Management Controller (CMC) RACADM CLI command "getniccfg" does not get VLAN info.


Answer

When setting VLAN parameters using the CMC setniccfg no VLAN information is visible using the CMC command "getniccfg".

Do not send any hardware, Dell engineering has fixed this problem in the latest CMC firmware.

Get the latest CMC firmware at CMC for M1000e SYSTEMS MANAGEMENT - WIKI.

More info on RACADM Command Line Interface for DRAC.




 


Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Identificación del artículo: SLN285957

Última fecha de modificación: 11/01/2013 12:00 AM


Califique este artículo

Preciso
Útil
Fácil de comprender
¿Este artículo fue útil?
No
Envíenos sus comentarios
Los comentarios no pueden contener estos caracteres especiales: <>"(", ")", "\"
Disculpe, nuestro sistema de comentarios está actualmente inactivo. Vuelva a intentarlo más tarde.

Muchas gracias por sus comentarios.