Knowledge Base

Remove, reseat or replace the fuser unit on the Dell 5460dn or 5465dnf printer


Article Summary: Remove, reseat or replace the fuser unit on the Dell 5460dn or 5465dnf printer

Caution! The fuser unit is very hot in operation, always switch off the printer and allow the fuser to cool before handling
  1. Open the rear door while puling gently
  2. The back door will come free from its hinges

    put the door to the side still connected by the black strap
  3. Pull on the black plastic handles to open the inner cover
  4. Turn the blue knobs anti-clockwise to release the fuser. When unscrewed they will pop forward but remain captive in the fuser unit
  5. Pull on the handle to remove the fuser
  6. Reverse the previous instructions to reseat or replace the fuser

If you require further assistance or wish to give us feedback, please engage our technical team on Twitter.

 


Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Artikel-id: SLN284174

Laatste wijzigingsdatum: 03/22/2016 03:32 PM


Beoordeel dit artikel

Nauwkeurig
Nuttig
Eenvoudig te begrijpen
Was dit artikel nuttig?
Ja Nee
Stuur ons feedback
Opmerkingen mogen geen speciale tekens bevatten: <>() \
Excuses, ons feedbacksysteem is momenteel offline. Probeert u het later nog eens.

Hartelijk dank voor uw feedback.