База знаний

071-300 and 072-300 Close Feeder Cover Errors on the Dell 3000cn, 3010cn, 3100cn Laser Printers


Article Summary: This article provides information on "071-300 and 072-300 Close Feeder Cover Errors on the Dell 3000cn, 3010cn, 3100cn Laser Printers".


Table of Contents:
  1. 071-300 and 072-300 Close Feeder Cover Errors on the Dell 3000cn, 3010cn, 3100cn Laser Printers


Issue 1.


071-300 and 072-300 Close Feeder Cover Errors on the Dell 3000cn, 3010cn, 3100cn Laser Printers


1. Verify the rear feeder cover opens and closes easily.

Rear Feeder Cover:



2. Check the feeder cover actuator and interlock for damage, and remove any foreign objects. If the actuator is damaged, Please contact Dell Technical Support for further advice.

Feeder Cover Actuator:



Feeder Cover Interlock:



3. Run diagnostics on the feeder cover interlock:

-> Turn the printer off using the power switch on the left side of the printer.

-> Press and hold the up and down buttons while turning the printer on. Release the buttons when Customer Mode appears on the printer LCD.

-> Press the down arrow until IOT DIAG appears, and then press Select.

-> Digital Input appears, press Select.

-> Select the diagnostic test for the paper tray that you are troubleshooting, and then press Select.

-> Tray 1: DI-f2

-> Tray 2: DI-fa

-> The printer LCD will display the diagnostic test followed by L 0, for example DI-f2 L 0.

-> Open and close the rear feeder cover. The number on the LCD increases by one each time the rear feeder cover is closed.

-> If the number does not increase from zero, Please contact
Dell Technical Support for further advice.

-> Press Cancel to stop the test, and then press Menu to exit diagnostics.

-> Turn the printer off, and then back on to resume normal operation.

4. If the diagnostic passes, but the error still occurs, Please contact
Dell Technical Support for further advice.

Click the button below to Tweet feedback or request assistance on anything in the above article.




Код статьи: SLN152047

Дата последнего изменения: 11/04/2016 01:56 PM


Оцените эту статью

Точно
Функционально
Просто понять
Помогла ли вам эта статья?
Да Нет
Отправьте нам свое мнение
Комментарии не должны содержать следующие специальные символы: <>()\
К сожалению, наша система обратной связи в настоящее время не работает. Повторите попытку позже.

Благодарим вас за отзыв.