База знаний

Configure Exchange Mail Routing Settings in Active Directory for Exchange 2013


Article Summary: Configure Exchange Mail Routing Settings in Active Directory for Exchange 2013



Determine the name of the Active Directory IP site link for which you want to set an Exchange cost. A lower cost value indicates a more preferred route. You can examine the contents of the routing table logs and view the data in the ADTopologyPath ID section to view details about the calculated least cost routing path between two Active Directory sites.

To set an Exchange-specific cost on an Active Directory site link, run the following command:
Set-AdSiteLink <ADSiteLinkIdentity> -ExchangeCost <Integer | $null>

This example sets an Exchange-specific cost of 10 on the IP site link named IPSiteLinkAB.
Set-AdSiteLink IPSiteLinkAB -ExchangeCost 10

This example clears the Exchange cost from the IP site link named IPSiteLinkAB.
Set-AdSiteLink IPSiteLinkAB -ExchangeCost $null

To verify that you have successfully set an Exchange cost on an Active Directory site link, do the following:

Run the following command:
Get-AdSiteLink | Format-List Name,ExchangeCost

Verify the Exchange cost is configured on the Active Directory site link.


 


Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Код статьи: SLN289403

Дата последнего изменения: 02/18/2014 12:00 AM


Оцените эту статью

Точно
Функционально
Просто понять
Помогла ли вам эта статья?
Да Нет
Отправьте нам свое мнение
Комментарии не должны содержать следующие специальные символы: <>()\
К сожалению, наша система обратной связи в настоящее время не работает. Повторите попытку позже.

Благодарим вас за отзыв.