Kunskapsbank

071-300 and 072-300 Close Feeder Cover Errors on the Dell 3000cn, 3010cn, 3100cn Laser Printers


Article Summary: This article provides information on "071-300 and 072-300 Close Feeder Cover Errors on the Dell 3000cn, 3010cn, 3100cn Laser Printers".


Table of Contents:
  1. 071-300 and 072-300 Close Feeder Cover Errors on the Dell 3000cn, 3010cn, 3100cn Laser Printers


Issue 1.


071-300 and 072-300 Close Feeder Cover Errors on the Dell 3000cn, 3010cn, 3100cn Laser Printers


1. Verify the rear feeder cover opens and closes easily.

Rear Feeder Cover:



2. Check the feeder cover actuator and interlock for damage, and remove any foreign objects. If the actuator is damaged, Please contact Dell Technical Support for further advice.

Feeder Cover Actuator:



Feeder Cover Interlock:



3. Run diagnostics on the feeder cover interlock:

-> Turn the printer off using the power switch on the left side of the printer.

-> Press and hold the up and down buttons while turning the printer on. Release the buttons when Customer Mode appears on the printer LCD.

-> Press the down arrow until IOT DIAG appears, and then press Select.

-> Digital Input appears, press Select.

-> Select the diagnostic test for the paper tray that you are troubleshooting, and then press Select.

-> Tray 1: DI-f2

-> Tray 2: DI-fa

-> The printer LCD will display the diagnostic test followed by L 0, for example DI-f2 L 0.

-> Open and close the rear feeder cover. The number on the LCD increases by one each time the rear feeder cover is closed.

-> If the number does not increase from zero, Please contact
Dell Technical Support for further advice.

-> Press Cancel to stop the test, and then press Menu to exit diagnostics.

-> Turn the printer off, and then back on to resume normal operation.

4. If the diagnostic passes, but the error still occurs, Please contact
Dell Technical Support for further advice.

Click the button below to Tweet feedback or request assistance on anything in the above article.




Artikel-ID: SLN152047

Senast ändrad: 11/04/2016 01:56 PM


Betygsätt den här artikeln

Korrekt
Användbart
Lätt att förstå
Var den här artikeln till nytta?
Ja Nej
Skicka dina synpunkter
Kommentarer får inte innehålla följande specialtecken: <>()\
Vårt feedbacksystem är tyvärr ut funktion just nu. Försök igen senare.

Tack för dina synpunkter.