Databáza poznatkov

How to configure SMTP Virtual server and Receive Connector in Exchange 2007/2010



Article Summary: This article provides information about how to configure SMTP Virtual server and Receive Connector in Exchange 2007/2010


Exchange needs a properly configured SMTP Virtual server/Receive connector to allow other mail servers to connect to your mail server to deliver the message.

By using EMC (Exchange management console) to expand Server Configuration and select Hub transport


Select the HUB server and check it has receive connectors Default and Client

Right click on Default receive connector and go to properties

Check if "anonymous" entry is checked on security groups tab.

On the network tab configure the correct IPs.

Check for all the listed hub transport servers.




Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Identifikátor článku: SLN285709

Dátum poslednej zmeny: 10/30/2014 12:53 PM


Ohodnotiť tento článok

Presné
Užitočné
Jednoducho pochopiteľné
Bol pre vás tento článok užitočný?
Áno Nie
Pošlite nám pripomienky.
Pripomienky obsahujú neplatný znak. Nie je možné používať špeciálne znaky <> () &#92;.
Ľutujeme, náš systém odosielania pripomienok je momentálne nefunkčný. Skúste znova neskôr.

Ďakujeme. Vaše pripomienky boli odoslané.