Consulta de temas

Article Summary:

This article provides information on removing and replacing the Belt Unit on the 3110cn Dell Laser Printer

Table of Contents:

1. Removing The Used Belt Unit
2. Installing A New Belt Unit

---

	Caution:
	Before performing any of the following procedures, read and follow the safety instructions in your Owner's Manual

	Notice:
	Make sure nothing touches or scratches the surface (black-colored film) of the belt unit. Scratches, dirt, or oil from your hands on the film of the belt unit may reduce print quality

	Notice:
	To protect the drums of the print cartridges against bright light, close the front cover within 5 minutes. If the front cover remains open for more than 5 minutes, print quality may deteriorate

Dell belt units are available only through Dell. To order by phone, see your Owner's Manual.

Dell recommends Dell belt units for your printer. Dell does not provide warranty coverage for problems caused by using accessories, parts, or components not supplied by Dell.

---

1.	Removing The Used Belt Unit

Note: Remove any jobs from the center output tray, and close the multipurpose feeder cover before opening the front cover

1. Make sure that the printer is turned off
2. Push the side button and open the front cover





3. Pull up on the belt release levers and rotate the belt unit up as shown in the illustration






Caution: Do not touch the inside of the printer. Some parts may be hot. Allow time for the printer to cool before attempting to remove parts in this area

4. Hold both sides of the belt unit with both hands and pull up the left side of the unit until the peg on the left side comes out of the groove. Then, shift the belt unit to the right and remove the unit from the printer

Back to Top

---

2.	Installing A New Belt Unit

1. Unpack a new belt unit
2. Insert the left peg into the corresponding left side belt unit hole, then align the right peg with the groove, and then push down on the right side of the belt unit to seat into place





3. Close the belt unit by pulling it down until it clicks





4. Remove the film cover from the installed belt unit and discard





5. Close the front cover

Back to Top

---

Click the button below to Tweet feedback or request assistance on anything in the above article

 

Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.