База знаний

iDRAC6 Web Interface Will Not Accept ": Colon Character in User Password


Article Summary: This article provides information on the iDRAC6 web GUI will not accept a ":" (colon) character in user password.



Question

If a user attempts to create or change a user password in the iDRAC6 web GUI, a colon is not accepted. The iDRAC6 web page will flash, and the password does not take.

A colon is an acceptable ASCII character, and is allowed to be used in the user password.



Answer

Use the local or remote RACADM CLI utilityto set the password when using a colon.

For more information on the RACADM CLI utility, see the Systems Management WIKI page RACADM Command Line Interface for DRAC.


Note: A fix was included in iDRAC6 firmware 1.30.

For more information on updating the iDRAC firmware, see the Systems Management WIKI page Dell Remote Access Controller - DRAC / iDRAC .



 


Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Код статьи: SLN283382

Дата последнего изменения: 10/11/2013 12:00 AM


Оцените эту статью

Точно
Функционально
Просто понять
Помогла ли вам эта статья?
Да Нет
Отправьте нам свое мнение
Комментарии не должны содержать следующие специальные символы: <>()\
К сожалению, наша система обратной связи в настоящее время не работает. Повторите попытку позже.

Благодарим вас за отзыв.