База знаний

Microsoft iSCSI Initiator source IP address incorrect in persistent target or favorite targets details

Article Summary: This article provides information about incorrect Microsoft iSCSI Initiator source IP addresses


After a host system reboot, when looking up the details of an iSCSI Initiator persistent target or a favorite
target, the source IP address may show another network interface (NIC)'s IP address on the host system.


Per Microsoft, if connection to an iSCSI target is confirmed successful using the correct source IP address,
it is safe to ignore the error condition. To confirm that all persistent target IP addresses are correct, open
a command prompt and run the 'iscsicli SessionList' command to review the settings from there.

Additional Information:

An example of this could be seen when setting up targets with Multipath I/O (MPIO) and assigning 2 NICs

as iSCSI source IP addresses, such as & Prior to reboot, all the details for source

IP addresses are displayed as correct. After reboot, however, the target details show a source IP address from

one of the other NICs in the server, such as a Production/Management LAN NIC IP address of

This particular issue has been reported from iSCSI Initiator versions 2.05 through v.2.08, at the earliest, and
is known to exist through to Windows Server 2008 R2.

Further reading on this condition may be found at:



Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Код статьи: SLN288457

Дата последнего изменения: 10/21/2014 09:18 AM

Оцените эту статью

Просто понять
Помогла ли вам эта статья?
Да Нет
Отправьте нам свое мнение
Комментарии не должны содержать следующие специальные символы: <>()\
К сожалению, наша система обратной связи в настоящее время не работает. Повторите попытку позже.

Благодарим вас за отзыв.