База знаний

How to block sender and domains in Exchange 2013


Article Summary: How to block sender and domains in Exchange 2013



To replace the existing values, run the following command:
Set-SenderFilterConfig -BlockedSenders <sender1,sender2...> -BlockedDomains <domain1,domain2...> -BlockedDomainsAndSubdomains <domain1,domain2...>

To add or remove entries without modifying any existing values, run the following command:
Set-SenderFilterConfig -BlockedSenders @{Add="<sender1>","<sender2>"...; Remove="<sender1>","<sender2>"...} -BlockedDomains @{Add="<domain1>"

To verify that you have successfully configured blocked senders, do the following:

Run the following command:
Get-SenderFilterConfig | Format-List BlockedSenders,BlockedDomains,BlockedDomainsAndSubdomains

Verify the values displayed are the values you configure
 


Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Код статьи: SLN289417

Дата последнего изменения: 02/18/2014 12:00 AM


Оцените эту статью

Точно
Функционально
Просто понять
Помогла ли вам эта статья?
Да Нет
Отправьте нам свое мнение
Комментарии не должны содержать следующие специальные символы: <>()\
К сожалению, наша система обратной связи в настоящее время не работает. Повторите попытку позже.

Благодарим вас за отзыв.