Knowledge Base

Removing and Reseating the Belt Unit / Transfer Belt on the Dell 3110cn, 3115cn or 3130cn Color Laser Printer



  1. Make sure the printer is powered off.

  2. Push the side button and open the front cover (Figure 1).


    Figure 1: Opening the Front Cover

  3. Hold the handles of the belt unit / transfer belt as shown (Figure 2) and open the unit fully.


    Figure 2: Removing the Transfer Belt

    Caution:  
      Do not touch the inside of the printer. Some parts may be hot. Allow time for the printer to cool before attempting to remove parts in this area.  

  4. Hold both sides of the belt unit / transfer belt with both hands and pull up the right side of the unit until the peg on the right side comes out of the groove (Figure 3).


    Figure 3: Removing the Peg From the Groove

  5. Shift the belt unit / transfer belt to the right and remove the unit from the printer.

  6. Insert the left peg into the hole, and align the other peg with the groove and push down on the right side of the belt unit / transfer belt (Figure 4).


    Figure 4: Aligning the Pegs

  7. Close the belt unit / transfer belt by pulling it down until it clicks (Figure 5).


    Figure 5: Closing the Transfer Belt

  8. Close the front cover (Figure 6).


    Figure 6: Closing the Front Cover

  9. With the power on, open the front cover and visually inspect the belt unit / transfer belt for scratches or damage.

  10. To inspect the entire surface of the belt unit / transfer belt, open and close the front cover three times.

    Note:  
      Each time the front cover is open, the belt unit / transfer belt rotates one-third of the way around the track.  
 


Article ID: SLN122988

Last Date Modified: 02/27/2011 12:00 AM


Rate this content

Accurate
Useful
Easy to understand
Did this article solve your problem?
Yes
No
Send us feedback
CAPTCHA
Change the CAPTCHA codeSpeak the CAPTCHA code
 
Enter Captcha Code
There is an error with an entry. Please try again entering your CAPTCHA code.
Feedback shows invalid character, not accepted special characters are <> () \
Sorry, our feedback system is currently down. Please try again later.