Knowledge Base

How to install Background Intelligent Transfer Service







This article addresses how to install Background Intelligent Transfer Service on a server running Windows Server 2012 R2 Core using Windows PowerShell


Solution:

Perform the following steps to install BITS on a server running Windows Server Core.

1. Type Start PowerShell in the Command Prompt window to start Windows PowerShell.

2. Type dism /online /enable-feature /featurename:bits and press Enter to install BITS.

Additional Information:

This information applies to Windows Server 2012 and Windows Server 2012 R2.

Additional information about BITS can be found on TechNet.

BITS administration Windows PowerShell Cmdlets can be found on TechNet.


Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Article ID: HOW10274

Last Date Modified: 09/15/2014 09:47 AM


Rate this article

Accurate
Useful
Easy to understand
Was this article helpful?
Yes No
Send us feedback
Comments cannot contain these special characters: <>()\
Sorry, our feedback system is currently down. Please try again later.

Thank you for your feedback.