Knowledge Base

How to Remove, Reseat or Replace the Fuser on the 3130cn / 3130cdn Dell Laser Printer


Table of Contents:

  1. How to Remove, Reseat or Replace the Fuser on the 3130cn / 3130cdn Dell Laser Printer

This article provides information on "How to Remove, Reseat or Replace the Fuser on the 3130cn / 3130cdn Dell Laser Printer"


1. How to Remove, Reseat or Replace the Fuser on the 3130cn / 3130cdn Dell Laser Printer

  1. Switch the printer off, open the front cover.
  2. Locate the duplex gate.



  3. Locate the gray fuser retention clips.



  4. Slide the fuser unit forward.

  5. Then lift to remove.

Perform the steps in reverse order to reseat or replace the fuser unit.

More info can be found in the 3130cn User’s Guide.

If these steps do not correct the problem, please contact Dell Technical Support.

Back to Top



Article ID: SLN284839

Last Date Modified: 08/03/2015 02:04 PM


Rate this article

Accurate
Useful
Easy to understand
Was this article helpful?
Yes No
Send us feedback
Comments cannot contain these special characters: <>()\
Sorry, our feedback system is currently down. Please try again later.

Thank you for your feedback.