Consulta de temas

Troubleshoot repeating defects by measuring the interval on the Dell 3130cn or 3130cdn laser printer


Article Summary: How to troubleshoot repeating defects by measuring the interval on the Dell 3130cn or 3130cdn laser printer

Print quality issues that repeat at set intervals on the page are often caused by a damaged or contaminated roller in the printer. Measuring the interval the defects occur at can identify the faulty component.
  1. Print the contamination check test page.
  2. Measure, in millimetres, the distance from the top of one defect to the top of the next



  3. Check the table below, replace the part indicated if possible

Component Interval (mm) Replaceable Part
Drum 75.4 Toner Cartridge
BCR 28.3 Toner Cartridge
BCR Cleaner Roll 25.1 Toner Cartridge
Sleeve (K) 27.9 Toner Cartridge
Sleeve (Y,M,C) 27.9 Toner Cartridge
1stBTR 31.4 Transfer Belt
Drive Roll 56.9 Transfer Belt
Fuser Roll 82.7 Fuser
Fuser Belt 94.2 Fuser
Pinch Roll 18.8 Fuser
Exit Roll 43.1 Fuser
Exit Pinch Roll 31.4 Fuser




If you require further assistance or wish to give us feedback, please engage our technical team on Twitter.
 


Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Identificación del artículo: SLN286139

Última fecha de modificación: 11/25/2013 12:00 AM


Califique este artículo

Preciso
Útil
Fácil de comprender
¿Este artículo fue útil?
No
Envíenos sus comentarios
Los comentarios muestran caracteres no válidos, los caracteres especiales que no se aceptan son <> () &#92;
Disculpe, nuestro sistema de comentarios está actualmente inactivo. Vuelva a intentarlo más tarde.

Gracias. Sus comentarios se han enviado.