Knowledge Base

How do I disable loading of Creative Launcher at system startup? - Technical Tip - 148873




Disable the SoundBlaster Live Creative Launcher® tool bar.

The following procedure will disable the SoundBlaster Live Creative Launcher tool bar.

  1. Click START | RUN.
  2. In the "Open" box, type:
    msconfig
  3. Click Ok.
  4. This will bring up the "System Configuration Utility" (See Figure 1).

    Figure 1


  5. Click the Startup tab on the far right.
  6. Look down the list for Creative Launcher .
  7. Uncheck the box in front of this entry by clicking on the check mark once.*
  8. Click OK.
  9. At this point, you will be asked to restart your system. Click YES.

Creative Launcher is now disabled. It will not load when the system starts up. It will still be available by clicking on START | PROGRAMS | CREATIVE.

*This program can be re-enabled by rechecking the Creative Launcher box.

Dell assumes no responsibility, expressed or implied, regarding inaccuracies or the consequences of any action taken as a result of the information provided herein.



 
Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Article ID: SLN38875

Last Date Modified: 08/02/2010 12:00 AM


Rate this article

Accurate
Useful
Easy to understand
Was this article helpful?
Yes No
Send us feedback
Comments cannot contain these special characters: <>()\
Sorry, our feedback system is currently down. Please try again later.

Thank you for your feedback.