Knowledge Base

Installing the Dell Utility Partition for Use with VMWare ESX - KB Article - 288955




VMWare ESX Does Not Allow the Specification of the Bootloader Location

It is easy to install and use the utility partition with most Linux distributions by installing the Linux bootloader to the first linux (boot) partition. This leaves the Master Boot Record (MBR) untouched, which will allow for the <F10> option to load the Dell Utility Partition.

VMWare ESX, however, installs the bootloader to the MBR and does not provide an option to install the bootloader elsewhere. To allow the utility partition to function as designed and be able to retain use of the VMWare installation, some additional steps are needed.



Install the Dell Utility Partition with VMWare ESX

Note:
If installing to a system which uses a RAID controller you must have a RAID array created and initialized prior to performing these steps.

  1. Install Dell Utility Partition from Dell Server Assistant (DSA) CD. For more information, refer to the following Dell Knowledge Base Article: "How to Install the Utility Partition on A Dell PowerEdge Server" Article ID: 131204.

  2. Install VMWare and choose the Manual Partitioning option to manually partition the drives.

    Note:
    Refer to the deployment guide for your version of VMWare ESX at http://support.dell.com or http://www.vmware.com for more information.

  3. Create additional partitions on the drive as needed.

    Note:
    Do not modify or delete the existing partition, /dev/sda1, as this is the utility partition.

  4. After the installation of VMWware is complete, login to the service console as root.

  5. At a command line, type mount | grep boot, and then press the <Enter> key.
    The partition where /boot is located is displayed. Example: /dev/sda2 on /boot type ext3 (rw)

  6. Locate and change the boot=/dev/sda line in the /etc/lilo.conf file to referrence the value returned by the mount | grep boot command. Example: Where /dev/sda2 is returned, you would change the value to boot=/dev/sda2.

  7. Save the changes to the /etc/lilo.conf file.

  8. At a command line, type lilo -v, and then press the <Enter> key.
    The VMWware bootloader is written to the first sector of the boot partition specified in /etc/lilo.conf.

    Note:
    The output should end with Writing boot sector. If it does not, the boot sector was not written correctly.

  9. Boot to the DSA and re-install the utility partition.

  10. Pressing the <F10> key should now successfully load the utility partition during boot.



 
Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Artikel-id: SLN60647

Laatste wijzigingsdatum: 10/31/2012 12:00 AM


Beoordeel dit artikel

Nauwkeurig
Nuttig
Eenvoudig te begrijpen
Was dit artikel nuttig?
Ja Nee
Stuur ons feedback
Opmerkingen mogen geen speciale tekens bevatten: <>() \
Excuses, ons feedbacksysteem is momenteel offline. Probeert u het later nog eens.

Hartelijk dank voor uw feedback.