Knowledge Base

The native i810_audio module in Red Hat Enterprise Linux (RHEL) 3 does not function on the Dell PowerEdge 400SC server. - KB Article - 174288


The native i810_audio module in Red Hat Enterprise Linux 3 does not function on the PowerEdge 400SC.

The i810_audio module in the Red Hat Enterprise Linux 3 kernel does not fully support the integrated sound controller on the Dell PowerEdge 400SC. The operating system identifies the controller and configures it correctly, but the audio does not function.



Update the i810_audio module.

A driver to fully support the audio controller is available on the System Support CD and from the Dell Support website at http://support.dell.com.

NOTE: If Dell preinstalled your operating system or you installed it using the System Support CD, then this updated driver was installed.



 


Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Article ID: SLN85786

Last Date Modified: 11/13/2010 12:00 AM


Rate this article

Accurate
Useful
Easy to understand
Was this article helpful?
Yes No
Send us feedback
Comments cannot contain these special characters: <>()\
Sorry, our feedback system is currently down. Please try again later.

Thank you for your feedback.