Base de conhecimento

Changing Port Setting on the Show All Pages Sets Ports to 1000/Full Duplex on the Dell PowerConnect 6024 an 6024F Switch - Product Support Quick Note (PSQN) - 172180


Changing Port Setting on the Show All Pages Sets Ports to 1000/Full Duplex.

When a port setting in the Show All page is changed via the web browser interface (WBI), all ports are assigned a speed of 1000 and duplex full settings.

Steps to repeat:

  1. Connect to the PowerConnect 6024 or 6024F switch via the WBI.
  2. Click Switch.
  3. Click Ports.
  4. Click Port Configuration.
  5. Click Show All.
  6. Change any setting (such as shutting down a port).
  7. From the CLI, type Show Run and then press the <Enter> key.



Set the Port Speeds to their Appropriate Values Before Saving the Changes

When applying any setting via the web page, all settings are updated according to the values that appear on the page. Therefore, change the port settings to the appropriate values if you make any changes.



 


Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

ID do artigo: SLN48914

Data da última modificação: 11/13/2010 12:00 AM


Classifique este artigo

Preciso
Úteis
Fácil de entender
Este artigo foi útil?
Sim Não
Envie seus comentários
Os comentários não podem conter estes caracteres especiais: <>()\
Infelizmente, o nosso sistema de feedback está atualmente desativado. Tente novamente mais tarde.

Agradecemos o feedback.