Base de conhecimento

How to Configure NetFlow on your vSphere Distributed Switch (vDS) in VMware vSphere ESXi 5.x



Article Summary: This article provides information on how to configure NetFlow on your vSphere Distributed Switch (vDS) in vSphere 5.x.



How to Configure NetFlow on your vSphere Distributed Switch (vDS) in VMware vSphere ESXi 5.x :



  1. In the vSphere Client, go to the home screen and click on Networking
  2. Right click on the distributed port group for the switch you want to enable NetFlow and then click on Edit Settings
  3. Click on Monitoring, change the status to Enabled, and then click on the OK button
  4. Right click on the distributed switch and click on Edit Settings
  5. Click on the NetFlow tab
  6. Input the IP address of the NetFlow Collector, port, and an IP address you will assign for this vDS
  7. Click on the OK button




Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

ID do artigo: SLN285529

Data da última modificação: 10/07/2014 10:43 AM


Classifique este artigo

Preciso
Úteis
Fácil de entender
Este artigo foi útil?
Sim Não
Envie seus comentários
Os comentários não podem conter estes caracteres especiais: <>()\
Infelizmente, o nosso sistema de feedback está atualmente desativado. Tente novamente mais tarde.

Agradecemos o feedback.