Base de conhecimento

How to Install the Optional Finisher Guide Bar on the B5460dn / B5465dnf / S5830dn Dell Laser Printer


Table of Contents:

  1. How to Install the Optional Finisher Guide Bar on the B5460dn / B5465dnf / S5830dn Dell Laser Printer

This article provides information on "How to Install the Optional Finisher Guide Bar on the B5460dn / B5465dnf / S5830dn Dell Laser Printer"


1. How to Install the Optional Finisher Guide Bar on the B5460dn / B5465dnf / S5830dn Dell Laser Printer

Note:
Do not install any finisher on top of the high capacity output expander.

When using a staple finisher and 4‑bin mailbox, the staple finisher must always be on top.

An Optional Finisher Guide Bar may need to be installed when installing a 4-bin Mailbox, Staple Finisher, or Output Expander.

  1. Unpack the Guide Bar.

    Note: Attach the guide bar only to the optional finisher the is immediately on top of the printer.
  2. Turn the optional finisher over to expose the holes under it.

  3. Align the tabs of the guide bar with the holes of the finisher and then insert the tabs.

  4. Slide the guide bar to the right until it clicks into place.

Continue with the installation of the 4-bin Mailbox, Staple Finisher, or Output Expander.

More info can be found in the B5460dn User’s Guide , B5465dnf User’s Guide or the S5830dn User Guide.

If these steps do not correct the problem, please contact Dell Technical Support.

Back to Top



ID do artigo: SLN289219

Data da última modificação: 05/24/2016 11:46 AM


Classifique este artigo

Preciso
Úteis
Fácil de entender
Este artigo foi útil?
Sim Não
Envie seus comentários
Os comentários não podem conter estes caracteres especiais: <>()\
Infelizmente, o nosso sistema de feedback está atualmente desativado. Tente novamente mais tarde.

Agradecemos o feedback.