Base de conhecimento

Configuring the Adaptec SCSI controller settings to work with tape backup devices. - Technical Tip - 117551




Configure the Adaptec SCSI controller to work with tape backup devices.

Press <CTRL+A> during the boot process to enter the SCSI BIOS configuration utility. This applies to the Adaptec 7860 or the 7880 controllers, where the tape device is attached. Then select SCSI Disk Utilities and confirm what SCSI ID the unit resides on. Press <ESC> and select Configure/View Host Adapter Settings. Then follow these steps:

1. Press the <F6> key to restore the defaults.

2. Under additional options, choose SCSI device configuration. Then alter the Max Synch Transfer Rate for the SCSI ID of the tape unit and the CD-ROM. Set the level to as low as possible.

3. On the same page, for Send Start Unit Command set the value for NO for the tape device and the CD-ROM.

4. Then press <ESC> and save the changes.



 
Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

ID do artigo: SLN36822

Data da última modificação: 08/25/2010 12:00 AM


Classifique este artigo

Preciso
Úteis
Fácil de entender
Este artigo foi útil?
Sim Não
Envie seus comentários
Os comentários não podem conter estes caracteres especiais: <>()\
Infelizmente, o nosso sistema de feedback está atualmente desativado. Tente novamente mais tarde.

Agradecemos o feedback.