Consulta de temas

Memory Amount May be Misreported in Dell™ OpenManage™ IT Assistant on PowerApp.web™ 100 Appliance Server. - Technical Tip - 151383


Enter the System Setup (BIOS) and check the amount of RAM reported.

To validate that the correct amount of memory is installed in your PowerApp.web 100, enter the System Setup (BIOS) and check the amount of RAM reported there:

  1. Turn on your system.
    If your system is already on, shut it down and then turn it on again.
  2. Press the <F2> key as soon as you are prompted.

At the Main Menu, you can validate the amount displayed for Total Memory.



More information about memory amounts being misreported in Dell™ OpenManage™ IT Assistant on PowerApp™.web™ 100 appliance server.

When you launch the Dell OpenManage IT Assistant console and check the status of available memory, the amount may be erroneously reported.

In addition, total memory may be reported incorrectly in configurations of 256MB of RAM or greater. On all memory configurations, the total physical memory capacity is reported incorrectly.

The misreported amount of available and total physical memory will not affect normal operation of the PowerApp.web 100 appliance.



 


Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Identificación del artículo: SLN49256

Última fecha de modificación: 11/14/2010 12:00 AM


Califique este artículo

Preciso
Útil
Fácil de comprender
¿Este artículo fue útil?
No
Envíenos sus comentarios
Los comentarios no pueden contener estos caracteres especiales: <>"(", ")", "\"
Disculpe, nuestro sistema de comentarios está actualmente inactivo. Vuelva a intentarlo más tarde.

Muchas gracias por sus comentarios.