Troubleshoot repeating defects by measuring the interval on the Dell 3130cn or 3130cdn laser printer
How to troubleshoot repeating defects by measuring the interval on the Dell 3130cn or 3130cdn laser printer
Print quality issues that repeat at set intervals on the page are often caused by a damaged or contaminated roller in the printer. Measuring the interval the defects occur at can identify the faulty component.
Measure, in millimetres, the distance from the top of one defect to the top of the next
Check the table below, replace the part indicated if possible
BCR Cleaner Roll
Exit Pinch Roll
If you require further assistance or wish to give us feedback, please engage our technical team on Twitter.
Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.
Article ID: SLN286139
Last Date Modified: 11/25/2013 12:00 AM
Rate this article
Easy to understand
Was this article helpful?
Send us feedback
Feedback shows invalid character, not accepted special characters are <> () \
Sorry, our feedback system is currently down. Please try again later.
Thank you. Your feedback has been sent.
Feature not supported by browser
FireFox does not support this feature with a secure connection(https). For the best experience, we recommend using Internet Explorer or Chrome.