Base de connaissances

RACRESET causes iDRAC and Chassis Management Controller (CMC) IP Address to change or re-order when using DHCP.


Article Summary: This article provides information about expected behavior when using DHCP on iDRAC and CMC devices.


When executing a RACRESET command (RACADM RACRESET), the IP Address of the iDRAC and/or CMC may change when configured to use Dynamic Host Control Protocal (DHCP). Integrated Dell™ Remote Access Controller (iDRAC) accepts whatever Ip Address is provided by the DHCP server. It does not remember the old IP Address that was configured.

This normal behavior for the standard DHCP protocol. Similar behavior would occur for NICs configured with DHCP within Linux or Windows operating systems.




Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

ID de l'article : SLN165193

Date de la dernière modification : 01/16/2015 04:00 PM


Noter cet article

Précis
Utile
Facile à comprendre
Avez-vous trouvé cet article utile ?
Oui Non
Envoyez-nous vos commentaires
Les commentaires ne doivent pas contenir les caractères spéciaux : <>()\
Désolé, notre système de collecte des commentaires est actuellement indisponible. Veuillez réessayer ultérieurement.

Merci pour vos commentaires.