知识库

How to Replace the Fusing Unit on the C2665dnf Dell Laser Printer


Table of Contents:

  1. Removing The Fusing Unit
  2. Installing A Fusing Unit

This article provides information on "How to Replace the Fusing Unit on the C2665dnf Dell Laser Printer"

Replacing the Fuser on C26xx and C37xx Printers (01:03) - English Only


1. Removing The Fusing Unit

  1. Turn off the printer and wait for 30 minutes.
  2. Push down the latch toopen the rear cover.

  3. Grasp the grips on both sides of the fusing unit squeezing the lever under the left side grip, and then pull out the unit.

More info can be found in the C2665dnf User’s Guide.

Back to Top

2. Installing A Fusing Unit

  1. Unpack the new fusing unit.
  2. Make sure that the two tabs of the fusing unit align with the grooves on the printer, and then insert it into the printer until it clicks.

  3. Close the rear cover.

Note: After replacing the fusing unit, be sure to initialize its life counter by following the instructions in the accompanying manual.

More info can be found in the C2665dnf User’s Guide.

If these steps do not correct the problem, please contact Dell Technical Support.

Purchase Toner and other xxxx Dell Laser Printer Supplies

Dell Recycling

Back to Top



文章ID: SLN286264

上次修改日期: 04/04/2016 09:45 AM


评价此文章

准确性
有用性
易理解性
这篇文章对您有帮助吗?
向我们发送反馈
反馈包含无效字符,不接受以下特殊字符:<>() &#92;
抱歉,我们的反馈系统目前发生故障。请稍后重试。

谢谢!反馈已发送。