Databáze znalostí

Installing a 550 Sheet Feeder on Dell 1710 and 1710n Laser Printers


Article Summary: How to install a 550 sheet feeder on Dell 1710 and 1710n laser printers

Table of Contents:
  1. Fit the optional feeder to the printer
  2. Enable the feeder in the printer properties



1.

Fit the optional feeder to the printer


  1. Switch the printer off.
  2. Unpack the feeder and remove any packing material or tape.
  3. Place the feeder where the printer will be installed.
  4. Align the holes in the printer with the positioning posts on the optional feeder, then lower the printer into place.

    The printer is shown about to be lowered on to the optional feeder.

  5. Switch the printer on.

Back to Top


2.

Enable the feeder in the printer properties

  1. Open the printer properties dialogue.
  2. On the Install Options tab, highlight 550-sheet drawer then click Add and OK.

Back to Top


If you require further assistance or wish to give us feedback, please engage our technical team on Twitter.

 


Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

ID článku: SLN291097

Datum poslední změny: 06/22/2016 03:37 PM


Zhodnoťte tento článek

Přesné
Užitečné
Snadno srozumitelné
Byl tento článek užitečný?
Ano Ne
Zašlete nám svůj názor
Komentáře nesmí obsahovat tyto speciální znaky: <>() \
Je nám líto, ale náš systém zpětné vazby je v současné době mimo provoz. Zkuste to později.

Děkujeme za váš názor.