Databáze znalostí

Where is the cable for my Targus USB port replicator? - Technical Tip - 129947




Graphic of cable

  1. Place the port replicator on a flat surface, bottom-up.

  2. Slide the cable door to the open position (it looks like a battery door on other types of electronics). (Figure 1)


    Figure 1

  3. Unwind the desired length of cable and then pass it through the opening on the side of the replicator.

  4. Slide the door back to the closed position.



Located on the bottom

The Targus USB port replicator cable is stored on the bottom of the port replicator.



 
Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

ID článku: SLN67347

Datum poslední změny: 07/30/2010 12:00 AM


Zhodnoťte tento článek

Přesné
Užitečné
Snadno srozumitelné
Byl tento článek užitečný?
Ano Ne
Zašlete nám svůj názor
Komentáře nesmí obsahovat tyto speciální znaky: <>() \
Je nám líto, ale náš systém zpětné vazby je v současné době mimo provoz. Zkuste to později.

Děkujeme za váš názor.