Databáze znalostí

This article provides information on enabling, disabling and managing Windows Update settings on a server running Windows Server Core.

Perform these steps to specify Automatic for Windows Update using Server Configuration.

1. Type sconfig and press Enter to start Server Configuration.

2. Type 5 and press Enter to change the setting for Windows Update.

3. Type a and press Enter to specify Automatic for Windows Update.

Perform these steps to specify Manual for Windows Update using Server Configuration.

1. Type sconfig and press Enter to start Server Configuration.

2. Type 5 and press Enter to change the setting for Windows Update.

3. Type m and press Enter to specify Manual for Windows Update.

Perform these steps to specify Automatic for Windows Update using the Command Prompt.

1. Type net stop wuauserv and press Enter to stop the Windows Update service.

2. Type cscript c:\windows\system32\scregedit.wsf /AU 4 to specify automatic for Windows Update.

Perform these steps to specify Manual for Windows Update using the Command Prompt.

1. Type net stop wuauserv and press Enter to stop the Windows Update service.

2. Type cscript c:\windows\system32\scregedit.wsf /AU 1 to specify Manual for Windows Update.

Additional Information:

This information applies to Windows Server 2012 and Windows Server 2012 R2.

Setting Windows Update to Manual is essentially disabling it.

Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.