Databáze znalostí

---

Article Summary: This article provides information on configuring Windows Server Core network settings using Sconfig

---

Solution:

1. Type Sconfig and press Enter to start Server Configuration in the Windows Server Core Command Prompt window.



2. Type 8 and press Enter to configure Network Settings.



3. Type the Index# for the Network Interface Card (NIC) and press Enter to configure the NIC.



4. Type 1 and press Enter to configure the Set Network Adapter Address settings.



5. Type S and press Enter to select a static TCP/IP address.



6. Type the TCP/IP address and press Enter to specify a static IP address.



7. Type the subnet mask and press Enter or press Enter to accept the default subnet mask.



8. Type the default gateway TCP/IP address and press Enter to enter the default gateway address.



9. Type 2 and press Enter to Set DNS Servers.



10. Type the TCP/IP address of the preferred DNS server and press Enter to specify the DNS server.



11. Type an alternate DNS server and press Enter or press Enter to skip an alternate DNS server setting.



12. Click OK to acknowledge the Preferred DNS server setting dialog box.

Additional Information:

This information applies to Windows Server 2012 and Windows Server 2012 R2.

Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.