Databáze znalostí

Disabling NetBIOS Over TCP/IP on Hyper-V servers



Article Summary: This article is designed to address the best practices for disabling NetBIOS over TCP/IP on all iSCSI NIC's on a Windows server that is a member of a Hyper-V cluster using iSCSI



Solution:

Follow the steps in the solution to achieve this goal.

1. Open the Network Connections Control Panel tool by pressing the Windows Logo+R, type ncpa.cpl and press Enter.




2. Right-click on the iSCSI NIC and click Properties.




3. Select Internet Protocol Version 4 (TCP/IPv4) and click Properties.




4. Click Advanced...




5. Click on the WINS tab.





6. Click the box Disable NetBIOS over TCP/IP to disable NetBIOS over TCP/IP.

7. Click OK three times to complete the changes.

Additional Information:

Additional information about best practices for Hyper-V failover clustering can be found on TechNet.




Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

ID článku: SLN290774

Datum poslední změny: 08/27/2014 12:25 PM


Zhodnoťte tento článek

Přesné
Užitečné
Snadno srozumitelné
Byl tento článek užitečný?
Ano Ne
Zašlete nám svůj názor
Komentáře nesmí obsahovat tyto speciální znaky: <>() \
Je nám líto, ale náš systém zpětné vazby je v současné době mimo provoz. Zkuste to později.

Děkujeme za váš názor.