Knowledge Base

What is the Microsoft Loopback adapter? - KB Article - 162381




The Microsoft loop back adapter is a software simulation of an adapter.

The Microsoft loop back adapter is a software simulation of an adapter that Dell installs on all laptop computers running Windows NT. It is installed so that when the Operating System is updated with a service pack (currently Service Pack 4), the networking components will also be updated.

This component will not affect your networking. However, usually when TCP/IP protocol is added to the system, the loopback adapter will have DHCP enabled as its source of IP addresses. This causes the system to boot up slowly, and at least one DHCP failure error. For this reason, Dell strongly recommends the removal of the Microsoft Loopback adapter after installing the system''s own Network Interface Card.



 
Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Artikel-ID: SLN42766

Datum der letzten Änderung: 08/25/2010 12:00 AM


Diesen Artikel bewerten

Präzise
Nützlich
Leicht verständlich
War dieser Artikel hilfreich?
Ja Nein
Schicken Sie uns Ihr Feedback.
Die folgenden Sonderzeichen dürfen in Kommentaren nicht verwendet werden: <>()\
Derzeit ist kein Zugriff auf das Feedbacksystem möglich. Bitte versuchen Sie es später erneut.

Vielen Dank für Ihr Feedback.