Videnbase

Reseat the Duplex Tray on the 2330d and 2330dn Laser Printer


Article Summary: How to reseat the duplex tray on the 2330d and 2330dn laser printer

  1. Switch the printer off
  2. Remove the paper tray
  3. Turn the printer on to its side to expose the blue plastic duplex tray



  4. The duplex tray is held in place by two mounting points, one closed



    and one open



  5. To remove the tray open it to a 90° angle and disconnect it from the open mounting point



  6. When reseating the tray ensure the spring is correctly fitted



  7. Holding the spring under tension, insert the tray into the closed mounting point



  8. Open the tray to a 90° angle, then insert it in to the open mounting point





If you require further assistance or wish to give us feedback, please engage our technical team on Twitter.

 


Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Artikelnummer: SLN284496

Sidste ændringsdato: 01/06/2014 12:00 AM


Bedøm denne artikel

Nøjagtig
Nyttig
Nemt at forstå
Var denne artikel nyttig?
Ja Nej
Send os feedback
Kommentarer må ikke indeholde følgende specialtegn: <>()\
Vi beklager, men feedbacksystemet er nede i øjeblikket. Prøv igen senere.

Mange tak for din feedback.