Knowledge Base

Receive and Print Faxes Using BVRP

To receive and print faxes using the BVRP software program, perform the following steps:

1. Click the Start button.

2. Click All Programs.

3. Click Classic PhoneTools or FaxTools.
   The BVRP Fax Tools Interface window appears.
   You are now ready to receive a fax.

NOTE:

The computer must be turned on and Fax Tools must be launched in order to receive a fax. Be sure Receive mode is Fax is seen in the mode window. You will notice a green RDY button which indicates it is ready to receive an incoming fax.

4. From the BVRP Fax Tools Interface window, click the Configure button to begin printing the fax.

5. Click General Setup.
   The General Setup window appears.

6. Click to put a check in the Print Received Faxes box.

7. Click the OK button.

---

Dell Printer Additional Information

For additional assistance beyond what is provided in this article, you can E-mail or Chat with a Technical Support Representative at Dell support.

---

 

Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.