Consulta de temas

How do I install Red Hat Linux Advanced Server 2.1 on a PowerEdge server with an Adaptec 2944 or 3944 SCSI controller? - KB Article - 174392


At the boot: prompt type linux apic.

When you install AS on a system that has an Adaptec 2944 or 3944 SCSI controller, the system might hang. If your system has one or more of the controllers, at the boot: prompt type linux apic and press the <Enter> key.

Note: For more information about installing Red Hat Linux Advanced Server 2.1 see
Red Hat® Enterprise Linux AS (Version 2.1) Installation Instructions and Important Information.



 


Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

ID del artículo: SLN101876

Última fecha de modificación: 11/14/2010 12:00 AM


Valorar este artículo

Acertado
Útil
Fácil de entender
¿Le ha resultado útil este artículo?
No
Envíenos sus comentarios
Se ha introducido un carácter no válido en los comentarios. Los caracteres especiales no aceptados son los siguientes: <> () &#92;
Lo sentimos. El sistema de envío de comentarios no está operativo en estos momentos. Vuelva a intentarlo más tarde.

Gracias. Sus comentarios se han enviado.