Tietämyskanta

How do I replace the thermal paper on an Epson T-90 receipt printer? - Technical Tip - 132115




Replace the receipt paper.

Perform the following steps to replace the receipt paper:

  1. Lift the cover-open lever. (Figure 1)


    Figure 1


  2. Open the paper roll cover. (Figure 2)


    Figure 2


  3. Insert the paper roll as shown below. (Figure 3)


    Figure 3

    NOTE: Install the paper roll in the direction shown below. (Figure 4)



    Figure 4


  4. Pull up a little paper as shown below. (Figure 5)


    Figure 5


  5. Close the printer. (Figure 6)


    Figure 6



 
Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Artikkelin tunnus: SLN67131

Muokattu viimeksi: 07/29/2010 12:00 AM


Arvostele tämä artikkeli

Tarkka
Hyödyllinen
Helppo hahmottaa
Oliko tästä artikkelista hyötyä?
Kyllä Ei
Lähetä meille palautetta
Kommenteissa ei voi olla seuraavia erikoismerkkejä: <>()\
Pahoittelumme, palautejärjestelmä ei ole nyt käytettävissä. Yritä myöhemmin uudelleen.

Kiitos palautteestasi.