Knowledge Base

---

Article Summary: This article addresses how to install DHCP Server on a server running Windows Server 2012 R2 Core using Windows PowerShell

---

Solution:

Perform the following steps to install DHCP Server on a server running Windows Server Core.

1. Type Start PowerShell in the Command Prompt window to start Windows PowerShell.

2. Type Install-WindowsFeature DHCP and press Enter to install DHCP Server.

Additional Information:

This information applies to Windows Server 2012 and Windows Server 2012 R2.

Additional information about DHCP Server can be found on TechNet.

DHCP deployment and administration Windows PowerShell Cmdlets can be found on TechNet.

Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.