Consulta de temas

RACRESET causes iDRAC and Chassis Management Controller (CMC) IP Address to change or re-order when using DHCP.


Article Summary: This article provides information about expected behavior when using DHCP on iDRAC and CMC devices.


When executing a RACRESET command (RACADM RACRESET), the IP Address of the iDRAC and/or CMC may change when configured to use Dynamic Host Control Protocal (DHCP). Integrated Dell™ Remote Access Controller (iDRAC) accepts whatever Ip Address is provided by the DHCP server. It does not remember the old IP Address that was configured.

This normal behavior for the standard DHCP protocol. Similar behavior would occur for NICs configured with DHCP within Linux or Windows operating systems.




Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

Identificación del artículo: SLN165193

Última fecha de modificación: 01/16/2015 04:00 PM


Califique este artículo

Preciso
Útil
Fácil de comprender
¿Este artículo fue útil?
No
Envíenos sus comentarios
Los comentarios no pueden contener estos caracteres especiales: <>"(", ")", "\"
Disculpe, nuestro sistema de comentarios está actualmente inactivo. Vuelva a intentarlo más tarde.

Muchas gracias por sus comentarios.