知識庫

Create a Receive Connector to receive messages from an internal Exchange server in Exchange 2013



Article Summary: This article contains information about creating a Receive Connector to receive messages from an internal Exchange server in Exchange 2013



In the EAC, navigate to Mail flow > Receive connectors. Click Add Add Icon to create a new Receive connector.

On the New receive connector page, specify a name for the Receive connector and then select Hub transport for the Role. In this case we assume you want to route mail within your network, not into and out of the organization.

Choose Internal for the type. The connector is configured with Exchange server authentication.

If the Remote network settings page lists 0.0.0.0-255.255.255.255, which means that the Receive connector receives connections from all IP addresses, click Remove Remove to remove it. Click Add Add Icon, add the IP address for the server you want to receive mail from, such as 192.168.1.1, and click Save.

Click Finish to create the connector.




Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

文章 ID: SLN288360

上次修改日期: 10/23/2014 01:58 PM


為本文評分

準確
實用
易懂
這篇文章對您有用嗎?
傳送意見反應
意見反應中有無效的字元,不接受的特殊字元如下 <> () &#92;
很抱歉,我們的意見回饋系統目前關閉中。請稍後再試。

感謝您。您的意見已送出。