知識庫

Why am I unable to access devices attached to my QLogic HBA when my primary path has a failure and the system has been rebooted? - KB Article - 164445




Why am I unable to access devices attached to my QLogic HBA when my primary path has a failure and the system has been rebooted?

QLDirect will not find devices on the failover path if no devices are detected on the primary controller during boot.

QLDirect is a runtime failover driver, not a boot time driver. QLDirect loads after the disk driver has already loaded and the scan on the bus has occurred. If the primary controller is offline, either by failure or if the cable has been pulled, the controller will not be able to find any drives.

NOTE:If the primary path is unavailable due to a failed HBA, the failover path can be designated as the primary path within QLCONFIG.



 
Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

文章 ID: SLN32372

上次修改日期: 08/01/2010 12:00 AM


為本文評分

準確
實用
易懂
這篇文章對您有用嗎?
傳送意見反應
評語中不得包含下列特殊字元:<>()\
很抱歉,我們的意見回饋系統目前關閉中。請稍後再試。

感謝您的寶貴意見。