知識庫

Why am I unable to manually disable auto-negotiation and set duplex speed using ethtool on Broadcom NICs in Red Hat Enterprise Linux (RHEL) version 3.0? - KB Article - 174260


The ethtool will not function correctly when using the Red Hat Enterprise Linux 3 native tg3 module.

The tg3 module in the 2.4.21-4.EL kernel does not allow you to manually disable auto-negotiation and set the duplex speed using ethtool.



Update the tg3 module.

An updated tg3 module that resolves this issue is available on the Server Assistant CD or from the Dell Support website at http://support.dell.com.

NOTE: If Dell preinstalled your operating system or you installed it using the Server Assistant CD, then this updated driver was installed. This issue will also be fixed in a later errata kernel.



 


Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

文章 ID: SLN101437

上次修改日期: 11/14/2010 12:00 AM


為本文評分

準確
實用
易懂
這篇文章對您有用嗎?
傳送意見反應
意見反應中有無效的字元,不接受的特殊字元如下 <> () &#92;
很抱歉,我們的意見回饋系統目前關閉中。請稍後再試。

感謝您。您的意見已送出。