Knowledge Base

Dell Latitude E6520 Removal Guide for the Keyboard Trim and Keyboard


Table of Contents :

  1. Keyboard Trim
  2. Keyboard

This article provides information on removing components from a Latitude E6520


1. Keyboard Trim

1. Pre-Removal Instructions Before removing the Keyboard Trim:

  • During installation or removal of any hardware always ensure all data is backed up properly
  • Disconnect any telephone, network, or USB cables from the computer
  • Disconnect the computer and all attached devices from their electrical outlets

2. Pry the keyboard trim up along the top by using a scribe.




3. Pry up the keyboard trim along the sides and bottom.




4. Pry up the keyboard trim from the bottom center.




5. Lift up to remove the keyboard trim from the unit.




6. Complete




Back to Top


2. Keyboard

1. Pre-Removal Instructions Before removing the Keyboard:

  • During installation or removal of any hardware always ensure all data is backed up properly
  • Disconnect any telephone, network, or USB cables from the computer
  • Disconnect the computer and all attached devices from their electrical outlets
  • Remove the Battery and Keyboard Trim



2. Remove the three screws from the bottom of the system.




3. Remove the three screws from the keyboard.




4. Flip the keyboard over.




5. Lift the keyboard cable clip.




6. Remove the keyboard from the system board.




7. Remove the tape securing the keyboard cable from the keyboard.




8. Disconnect the keyboard data cable from the keyboard and remove.



Back to Top

Return to the Latitude E6520 Teardown/Removal Index.





Article ID: SLN290737

Last Date Modified: 10/04/2017 09:41 AM


Rate this article

Accurate
Useful
Easy to understand
Was this article helpful?
Yes No
Send us feedback
Comments cannot contain these special characters: <>()\
Sorry, our feedback system is currently down. Please try again later.

Thank you for your feedback.