Knowledge Base

Brocade 825 Fibre Card not being seen in Windows 2012 R2


Brocade 825 Fibre Card not being seen in Windows 2012 R2



Check the following to resolve the issue:

  • SFP+ modules and Brocade Card compatibility
  • Check status LEDs on the card
  • Check cables are functioning. i.e. swap cables with know good.
  • Check slot priority on the motherboard
  • Ensure correct speed setting in BIOS of the card. If in doubt, set to Auto.
  • Update Windows 2012 R2 driver from Qlogic web site.

Quick Tips content is self-published by the Dell Support Professionals who resolve issues daily. In order to achieve a speedy publication, Quick Tips may represent only partial solutions or work-arounds that are still in development or pending further proof of successfully resolving an issue. As such Quick Tips have not been reviewed, validated or approved by Dell and should be used with appropriate caution. Dell shall not be liable for any loss, including but not limited to loss of data, loss of profit or loss of revenue, which customers may incur by following any procedure or advice set out in the Quick Tips.

ID articolo: SLN292436

Data ultima modifica: 11/26/2015 08:52 AM


Valuta questo articolo

Preciso
Utile
Facile da comprendere
Questo articolo ti è stato d'aiuto?
No
Inviaci un feedback
I commenti non possono contenere i seguenti caratteri speciali: <>() \
Spiacenti, il sistema di feedback al momento non è attivo. Riprova più tardi.

Grazie per il tuo feedback.